Beurer Microdermabrasion 606.66 Manual De Usuario

14

Before you start using the device, make sure that your face is clean, dry and free of any traces of products such as 

powder, cream or make-up.

Carry out a skin test 24 hours before using the device. Test the device at the lowest intensity level on small, incon-

spicuous areas of your neck. If after 24 hours the tested area is red or painful, do not use the device.

• Do not use the device more than once a week. 

• Immediately after use, the treated skin may be slightly reddened and in very rare cases there may be small 

spots of bleeding under the skin.

• For one day before and one day after use, avoid activities that cause you to perspire, such as saunas, tanning 

beds and sun exposure.

The device can also be used twice a week for non-sensitive problem skin (with a break of at least 48 hours between use).

1. Connect the mains adapter to the device and plug the adapter into the socket.

2. Press the Open button to open the device.

3. Insert a single-use filter into the end of the tube. 

4. Connect the end of the tube to the hand-held device.

5. Place the attachment you wish to use on the tip of the hand-held device.

6. Now press the ON/OFF button to switch on the device. The intensity level display 

starts to light up. You are now at the lowest intensity level. 

7. Start the treatment at the lowest intensity level initially. Place the hand-held device on your face and move it over 

the skin. Make sure that you do not move the hand-held device over one part of the face more than once. Further 

details on treatment can be found in Section "6.3 Application areas".