C&E FS20 4-channel Surfa-mount Switching capacity (max.) 3680 VA 46135 Hoja De Datos

Before assembling and using the device, make sure you take note of all the
safety and assembly instructions in this user manual.

Only people who are appropriately trained are permitted to carry out work on
voltage-carrying parts. If you are not appropriately trained, please consult a
qualified electrician who is authorised to carry out such work.

Any incorrect work carried out on the supply voltage may lead to a fatal electric
shock. You endanger not only your own life but also the lives of others!

Two important factors play a part in determining a suitable installation location:

• Any cabling that may already exist
• Good radio reception

We therefore recommend that you test the radio reception at the installation location.

• Disconnect the remote switch from the supply voltage!

• Open the remote switch’s casing by removing the 4 screws on the upper surface of the

device using a suitable screwdriver.

• There is 1 hole in each of the device’s 4 corners.

You can use a suitable pencil to mark the position of the remote switch through the four
holes, in order to drill holes in a wall to insert dowels, for example.

The installation location must be positioned so as to allow the rigid installation cables to be
securely guided into the remote switch.

Make sure that the drill holes or screws do not damage any cables, power
supply lines, gas pipes, or similar! Life-threatening danger!

Use appropriate screws/dowels to attach the remote switch at the installation location.

The 4 openings/plastic locknuts for the consumer load must face downwards
to the ground.