C&E Profi Funk-Farb-Wetterstation Wireless Weather Station W237-8+W266G8 9129c19 Hoja De Datos

Now align the wind vane with the tip towards North. There is a compass at the top of the wind vane (10). 
Then attach the wind vane by an adhesive strip and take the weather station into operation. 

  After the weather station has successfully completed the search for the outdoor sensor and the sensor 

search has been terminated, remove the adhesive strip again.

  Permanent lighting of the display is only possible if the enclosed plug-in mains adapter is connected. In this 

case, the batteries are used to retain data in case of power outage (or if the weather station is to be taken 

to a different location and you need to disconnect the plug-in mains adapter for this).

 

In pure battery operation, the display lighting is activated for a few seconds every time a button is pushed 

to save power.

Open the battery compartment (7) on the rear of the weather station and insert 3 type AA/mignon batteries with correct 

polarity (observe plus/+ and minus/-). Close the battery compartment again.

 Like for the outdoor sensor, we recommend using only high-quality alkaline batteries for the weather stati-

on. 

 

If you want to use rechargeable batteries, always use special NiMH batteries with a low self-discharge.

Connect the low-voltage plug of the enclosed plug-in mains adapter to the corresponding round socket (8) on the rear 

of the weather station.
Then plug the plug-in mains adapter into a proper mains socket.

Right after inserting the batteries or connecting the plug-in mains adapter, the display will briefly display all display

segments.
Then the weather station emits a sound signal and the weather icon for weather forecast flashes in the upper left of

the display.
Use the buttons „CHANNEL/+/SEARCH“ (3) or „MEM/-“ (4) to set the current weather and briefly push the button

„MODE/SET“ (2).
The indications for outdoor temperature now flash in the display and the weather station scans for the outdoor sensor

signal. This will table about 3 minutes. Push no buttons at the weather station during this time and do not move the 

weather station.
Push the button „TRANSMIT“ (17) at the outdoor sensor to calibrate wind direction. The weather station then emits

a sound signal. 

  Do not forget to remove the adhesive strip from the wind vane that fastened it pointing North (see chapter 

9. b).