Cisco Aironet Converter Clip for Channel Grid Suspended Ceilings AIR-ACC-CLIP-20= Manual De Usuario
Los códigos de productos
AIR-ACC-CLIP-20=
R E V I E W D R A F T — C I S C O C O N F I D E N T I A L
3
Cisco Aironet Converter Clip for Channel Grid Suspended Ceilings (AIR-ACC-CLIP-20)
78-18348-01
Mounting an Antenna
Mounting an Antenna
Mounting an antenna on a channel grid suspended ceiling requires two converter clips. The clips attach
to the ceiling channel and must be disassembled before you can attach them.
to the ceiling channel and must be disassembled before you can attach them.
shows how the
converter clips are installed on a channel and how the antenna attaches to the converter clips.
Figure 2
Antenna Mounted on a Ceiling Channel
Follow these steps to mount the antenna on a suspended ceiling channel.
Step 1
Identify the location where you intend to mount the antenna.
Step 2
Raise the ceiling tiles on both sides of the channel. If desired, you can remove the tiles.
Step 3
Use a ruler to measure the distance between the center points of the antenna E-Z clips.
Step 4
Use a pencil to mark the distance you measured in Step 2 channel where you will install the converter
clips. Make sure the marks are above the channel so you can see them when you install the converter
clips.
clips. Make sure the marks are above the channel so you can see them when you install the converter
clips.
Step 5
Remove two converter clips from the mounting kit.
Step 6
Disassemble each converter clip by pushing on its OFF tabs using your thumb and forefinger. See
.
1
Channel converter clip
2
Antenna mounting E-Z clip