Jeti 11-channel receiver 2.4 GHz FHSS with Connector system JR 80001225 Manual De Usuario
Los códigos de productos
80001225
computer radio control system
EN
3.3 Binding
When using a new receiver or transmitter it is necessary to carry
out the binding process between them . Transmission between the
receiver and transmitter occurs in fully digital manner, therefore it is
necessary to identify and share the addresses of each device
communicating on the mutual 2.4GHz frequency band.
Procedure:
out the binding process between them . Transmission between the
receiver and transmitter occurs in fully digital manner, therefore it is
necessary to identify and share the addresses of each device
communicating on the mutual 2.4GHz frequency band.
Procedure:
1.
Insert the BIND PLUG (included in the receiver packing) into the
receiver socket labeled EXT.
2.
Switch-on the receiver – (connect a proper voltage supply to the
receiver). Binding of the receiver may now be performed within 60
seconds. After the 60 seconds elapse the receiver returns to setup
mode and the binding process must be repeated by starting again
from step 1.
3.
Switch-on the transmitter - the transmitter emits an acoustic
signal announcing detection of a new receiver.
Binding may be caried out with the aid of the JETIBOX instead of
using the BIND PLUG.
using the BIND PLUG.
The procedure is as follows:
1.
Connect the JETIBOX with the connecting cable to the receiver
output EXT.
2.
Switch-on the receiver - (connect a proper voltage supply to the
receiver).
3.
The receiver menu appears on the JETIBOX display. Select the
„Pairing“ menu item (push the right arrow button once from the
main receiver display) and then push the upward button. You now
have a period of 60 seconds to bind the receiver. After the 60