Futaba 10J F4109 Hoja De Datos

26

 An alarm or error indication may appear on the display of your transmitter for a number of 

reasons, including when the transmitter power switch is turned on, when the battery voltage is 

low, and several others. Each display has a unique sound associated with it, as described below.

LOW BATTERY ERROR: Warning sound: Continuous beep until transmitter is powered off.

The LOW BATTERY warning is displayed when the transmitter battery voltage drops below 4.1V. 

MIXING ALERT WARNING: Warning sound: Several beeps repeated until problem resolved or 

overridden. 

The MIXING ALERT warning is displayed to alert you whenever 

you turn on the transmitter with any of the mixing switches 

active. This warning will disappear when the offending switch 

or control is deactivated. Switches for which warnings will be 

issued at power-up are listed below. Throttle cut, idle-down, snap roll, airbrake, throttle-stick 

and condition, motor SW. If turning a switch OFF does not stop the mixing warning: The 

functions described previously probably use the same switch and the OFF direction setting 

is reversed. In short, one of the mixings described above is not in the OFF state. In this case, 

reset the warning display by pressing both  ＋ / － KEY at the same time.  Next, change one 

of the switch settings of the duplicated mixings.

*If "ESC mode" is chosen by "THR.CUT", a THR CUT will not start warning.

BACKUP ERROR: Warning sound: Several beeps (repeated continuously)

The BACKUP ERROR warning occurs when the transmitter memory is lost for any reason. If this 

occurs, all of the data will be reset when the power is turned on again.

Do not fly when this message is displayed: all programming 

has been erased and is not available. Return your transmitter to 

Futaba for service. 

A setup of warning of each sensor can be performed in TELEMETRY.