Blade BLH8000 Hoja De Datos

1 second

1 second

Sequence

Initialization failed

Pulsing red

IMU initialization

Red, green and blue fl ash once

Fully charged battery

Green (~2 second duration)

Fully discharged battery

Red (~2 second duration)

Return to home mode activated

Rapid red fl ashing

The quadcopter is in Bind mode

Rapid blue fl ashing

Emergency mode

(cycle power to reinitialize)

White fl ashing

Partial battery charge

Color indicates level of battery charge
(~2 second duration)

1 second

The motors will beep under the following conditions:

•  Any time the props stop spinning after they have 

been initialized. 

•  After 30 seconds of no throttle input

(waiting armed on the ground).

ESC power on

one short beep

Successful initialization

many continuous tones with increasing frequency

RC signal detected after start

one long tone

Bind detected

one long tone

Bind accepted (3 seconds after detected)

one long tone

Throttle stick in correct position for motor start

low, med, high (happy tone)

Cannot start motors because of low voltage

high, med, low (sad tone)

Cannot start motors because vehicle is tilted

high, med, low (sad tone)

Enter ESC ID assignment mode

loud high, low — high, low

GPS Lock Acquired/Lost

3 short beeps, pause, then 3 short beeps

Gyro, accelerometer sensor error

High, low, 1 short tone

Compass initialization error

High, low, 2 short tones

Pressure sensor initialization error

High, low, 3 short tones

GPS initialization error

High, low, 4 short tones

ESCs not detected

High, low, 6 short tones

Settings saved (i.e. when changed GPS on/off, etc)

Rapid low, med, high — low, med, high

Low-battery warning

Medium frequency, loud tone (every 3 seconds)

Emergency state warning
(also after ESC ID assignment)

Once per second loud medium tone