Albrecht Cb Transceiver Ae 2990 10190 Manual De Usuario

21 

This feature allows the user to save and recall specific frequency and operating mode. See 
Memory programming and Recall instructions.  

 

• Using 

“UP/DOWN” buttons select the desired frequency and mode to be saved. 

•  Press and release “FUNC” button and then press the “ML/MS” button, notice the 

“M “icon blinking on the right side on the display. 

•  Then press “SCAN/M/SCN” button to save in memory M1. 

 

•  Repeat procedures 1and 2 and save it to “MODE / H/L” button for memory M2,  

•  “STEP / CH/FREQ” button for M3, “CH9/19 / LOCK” button for M4 and “ 

SQ,MICG,RFG /RPT” for M5. 

 

Now You will use the Memory Load ML function: See Memory Save MS in last paragraph.  

 

• Press 

ML/MS button and then SCAN / MSCN to recall memory M1 

• Press 

ML/MS button and then MODE / H/L to recall memory M2 

• Press 

ML/MS button and then STEP/ CH/FREQ. to recall memory M3 

• Press 

ML/MS button and then CH9/19 / LOCK to recall memory M4.  

• Press 

ML/MS button and then SQ, MICG, RF-G/ RPT to recall memory M5. 

 

 
SCN (Scan) : Allows the radio to automatically scan through all frequency, stopping at any 
frequency that is busy with signals being communicated. It will remain on that frequency 
during the conversation, and will not reactivate scanning until roughly 5 seconds after the 
communication signal has ended. To activate, press the “SCN/M/SCAN” button. The word 
SCAN will appear on the display. To stop, press the “SCN/M/SCAN” button again. 

 

M/SCAN (Memory Scan): This feature allows the user to scan all the 5 saved channels to 
the memory. To Turn it “on”, press the “FUNC” button first and then followed by the 
“SCN/M/SCAN” button. To Turn-Off: Performed same procedure as mentioned above. 
 
Shift-Offset Frequency: To access press the “SCN/M/SCAN" button for 3 seconds or 
more, the shift frequency will appear on the display, then use the “up” and “down” button to 
select the desired shift frequency from 0 to 990 KHz. This function can only be activated 
when the unit is in Ham Radio mode. In CB, this function is not possible (and not needed at 
all).  
 

 

 
Allows selection between the four operational modes of the radio (AM/FM/USB/LSB). To 
select your desired mode, press the "Mode" button until you see the mode in which you 
desired. The order of appearance is FM then AM, then USB, and then LSB. 
FM  means Frequency modulation, this is the standard mode all over Europe, which is 
allowed in all countries. 
AM means Amplitude modulation, which is used by most truck drivers in continental Europe. 
In  SSB (Single Side Band) you will have the Upper Side Band USB and the Lower Side 
Band  LSB.  SSB is the mode for the longest possible communication distances. All