Texas Instruments TS3USB221 Evaluation Module TS3USB221EVM TS3USB221EVM Hoja De Datos
Los códigos de productos
TS3USB221EVM
TS3USB221/A/E
Output Select or
Ouput Enable
Output Select or
Ouput Enable
3.3-V LDO
Ouput Enable
Ouput Enable
10 kW
10 kW
www.ti.com
EVM Configuration and Description
3
EVM Configuration and Description
3.1
EVM Description
To conform to the USB 2.0 specification, the differential traces D+ and D- lines on the board are
impedance matched to 90-
impedance matched to 90-
Ω
differential. The trace length of the through-path and the trace length through
the TS3USB221/A/E switch are also matched for comparison purpose. The PCB is a simple four-layer
top-side populated board (see the schematic and PCB layout in
top-side populated board (see the schematic and PCB layout in
and
). The major
features of the hardware design are detailed in the following sections.
3.2
Jumper Configuration (J6 to J8)
The EVM has jumper J6 through J8 (see
) to provide configuration to the TS3USB221/A/E and the
3.3-V LDO. J6 allows switch output channel select, J7 provides switch enable control, and J8 provides
3.3-V LDO enable control.
3.3-V LDO enable control.
lists all of the jumpers in the EVM and their respective functionality (all
default settings are in bold).
Figure 3. Jumpers J6, J7, and J8 Configuration
Table 1. EVM Jumper Description
Jumper
Functionality
Configuration
Shunt J6 to select output 1
J6
TS3USB221/A/E Select
Open J6 to select output 2
Shunt J7 to enable the switch
J7
TS3USB221/A/E Enable
Open J7 to disable the switch
Shunt J8 to disable the LDO
J8
3.3V LDO Enable
Open J8 to enable the LDO
The EVM provides USB connectors J1 through J5 to interface with other USB devices. Depending on the
application need, the connectors can be de-soldered and changed to either type A or type B connector.
See
application need, the connectors can be de-soldered and changed to either type A or type B connector.
See
for the default connectors on the EVM.
Table 2. EVM Connector Description
Connector
Functionality
Configuration
Default as type B connector
J1
USB Connector
Can be replaced with type A connector
Default as type A connector
J2
USB Connector
Can be replaced with type B connector
Default as type B connector
J3
USB Connector
Can be replaced with type A connector
Default as type B connector
J4
USB Connector
Can be replaced with type A connector
Default as type B connector
J5
USB Connector
Can be replaced with type A connector
5
SCDU001A – July 2009 – Revised October 2009
TS3USB221/A/E High Speed USB 2.0 (480 Mbps) 1:2 Multiplexer/Demultiplexer
Switch Evaluation Module
Copyright © 2009, Texas Instruments Incorporated