Texas Instruments 2.5A, 10.8 to 13.2 Vin, SWIFT™ Converter Evaluation Module TPS54260EVM-597 TPS54260EVM-597 Hoja De Datos
Los códigos de productos
TPS54260EVM-597
Vout = 2 V / div
PH = 10 V / div
Inductor Current = 500 mA / div
Time = 2 usec / div
Vout = 2 V / div
PH = 10 V / div
Inductor Current = 500 mA / div
Time = 2 usec / div
www.ti.com
Test Setup and Results
2.10 Continuous Conduction Mode Operation
When the output current is greater than one half the peak to peak inductor current, the circuit is operating
in continuous conduction mode (CCM). The output voltage, PH node voltage and inductor current for CCM
is shown in
in continuous conduction mode (CCM). The output voltage, PH node voltage and inductor current for CCM
is shown in
Figure 10. Continuous Conduction Mode Operation
2.11 Discontinuous Conduction Mode Operation
When the output current is less than one half the peak to peak inductor current, the circuit is operating in
discontinuous conduction mode (DCM). The circuit enters DCM when the nominal output current falls
below 0.337 A. The output voltage, PH node voltage and inductor current for DCM is shown in
discontinuous conduction mode (DCM). The circuit enters DCM when the nominal output current falls
below 0.337 A. The output voltage, PH node voltage and inductor current for DCM is shown in
Figure 11. Discontinuous Conduction Mode Operation
9
SLVU372 – March 2009
TPS54260EVM-597 2.5-A, SWIFT™ Regulator Evaluation Module
Copyright © 2009, Texas Instruments Incorporated