Texas Instruments Serial Bus Evaluation Module SERIAL-BUS-EVM SERIAL-BUS-EVM Hoja De Datos
Los códigos de productos
SERIAL-BUS-EVM
3.1
Electrostatic Discharge Warning
3.2
Connecting the Hardware
www.ti.com
Serial-Bus-EVM Hardware Setup
Many of the components on the Serial-Bus-EVM are susceptible to damage by electrostatic discharge
(ESD). Customers are advised to observe proper ESD handling precautions when unpacking and handling
the EVM, including the use of a grounded wrist strap at an approved ESD workstation.
(ESD). Customers are advised to observe proper ESD handling precautions when unpacking and handling
the EVM, including the use of a grounded wrist strap at an approved ESD workstation.
CAUTION
Failure to observe ESD handling procedures may result in damage to EVM
components.
components.
To connect the two PCBs of the Serial-Bus-EVM together, gently push on both sides of the D-SUB
connectors (as shown in
connectors (as shown in
). Make sure that the two connectors are completely pushed together;
loose connections may cause intermittent operation.
Figure 3. Connecting the Two EVM PCBs
SBOU076 – September 2008
Serial-Bus Evaluation Module
5