Freescale Semiconductor Student Learning Kit with MC9S08QG8 DEMO9S08QG8E DEMO9S08QG8E Manual De Usuario

                                                                                                                                                                                                                                
4                                                                                                                                                           Freescale Semiconductor 
 

♦  Electrostatic Discharge (ESD) prevention measures should be used when handling this 

product.  ESD damage is not a warranty repair item. 

 
♦  Axiom Manufacturing does not assume any liability arising out of the application or use of 

any product or circuit described herein; neither does it convey any license under patent 
rights or the rights of others.  

 
♦  EMC Information on the APS08QG8SLK board: 

a)  This product, as shipped from the factory with associated power supplies and cables, 

has been verified to meet with FCC requirements as a CLASS A

 

product. 

b)  This product is designed and intended for use as a development platform for hardware 

or software in an educational or professional laboratory. 

c)  In a domestic environment, this product may cause radio interference in which case the 

user may be required to take adequate prevention measures. 

d)  Attaching additional wiring to this product or modifying the product operation from the 

factory configuration may affect its performance and cause interference with other 
apparatus in the immediate vicinity.  If such interference is detected, suitable mitigating 
measures should be taken.   

This development board uses option selection jumpers.  A jumper is a plastic shunt that 
connects 2 terminals electrically.  Terminology for application of the option jumpers is as 
follows: 

Jumper – a plastic shunt that connects 2 terminals electrically 
Jumper on, in, or installed - jumper is installed such that 2 pins are connected together 
Jumper off, out, or idle - jumper is installed on 1 pin only.  It is recommended that 
jumpers be idled by installing on 1 pin so they will not be lost. 
Cut-Trace – a circuit trace connection between component pads.  The circuit trace may 
be cut using a razor knife to break the default connection.  To reconnect the circuit, 
simply install a suitably sized 0-ohm resistor or attach a wire across the pads. 
 

Throughout this document, where used, the name APS08QG8SLK applies equally to the 
APS08QG8SLK, CSM9S08QG8SLK, and PBS08QG8SLK.