Freescale Semiconductor TWR-K60D100M Low-Power MCU with USB, Ethernet and Encryption Kit TWR-K60D100M-KIT TWR-K60D100M-KIT Manual De Usuario

5

Step-by-Step Installation Instructions

Install the  
Software and Tools

Install the P&E Micro Kinetis Tower
toolkit. The toolkit includes the
OSJTAG and USB-to-serial drivers.
These can be found on line at 
freescale.com/TWR-K60D100M.

Configure the  
Hardware

Install the included battery into the
VBAT (RTC) battery holder. Then,
connect one end of the USB cable 
to the PC and the other end to the 
power/OSJTAG mini-B connector
on the TWR-K60D100M module. 
Allow the PC to automatically
configure the USB drivers if needed.

Tilt the  
Board

Tilt the board side to side to see the 
LEDs on D7, D8, D9 and D11 light
up as it is tilted. While the board is 
held flat, touch the pads on D7, D8,
D9, D11 to toggle the LEDs.

Play the  
Memory Game

Press SW2 to play a memory recall 
game using the touch pads D7, 
D8, D9 and D11. A sequence will
light up, then press the touch pads 
in the order flashed. If an incorrect
sequence is touched or too much
time has elapsed, the LEDs will 
blink rapidly and the game will reset.

Press SW1 to return to the 
accelerometer demo.

In this quick start guide, you will learn how to set up the TWR-K60D100M module  
and run the default demonstration.