Freescale Semiconductor DEMO9S08DZ60 Demo Board DEMO9S08DZ60 DEMO9S08DZ60 Hoja De Datos
Los códigos de productos
DEMO9S08DZ60
MC9S08DZ60 Series Data Sheet, Rev. 4
Freescale Semiconductor
273
Chapter 13
Serial Peripheral Interface (S08SPIV3)
Serial Peripheral Interface (S08SPIV3)
13.1
Introduction
The serial peripheral interface (SPI) module provides for full-duplex, synchronous, serial communication
between the MCU and peripheral devices. These peripheral devices can include other microcontrollers,
analog-to-digital converters, shift registers, sensors, memories, etc.
between the MCU and peripheral devices. These peripheral devices can include other microcontrollers,
analog-to-digital converters, shift registers, sensors, memories, etc.
The SPI runs at a baud rate up to the bus clock divided by two in master mode and bus clock divided by
four in slave mode.
four in slave mode.
All devices in the MC9S08DZ60 Series MCUs contain one SPI module, as shown in the following block
diagram.
diagram.
NOTE
Ensure that the SPI should not be disabled (SPE=0) at the same time as a bit
change to the CPHA bit. These changes should be performed as separate
operations or unexpected behavior may occur.
change to the CPHA bit. These changes should be performed as separate
operations or unexpected behavior may occur.