Freescale Semiconductor Daughter Card for DEMOEM DCF51EM256 DCF51EM256 Manual De Usuario
Los códigos de productos
DCF51EM256
DEMOEM User Manual
13
4.4
Quick Startup
Only a few steps are required to get the DEMOEM up and running. Please
reference the Quick Start Guide.
reference the Quick Start Guide.
4.5
Hardware Setup
4.5.1
First-Time Connection
The DEMOEM may be connected to a PC through a USB port. Connection
steps are listed below in typical order:
steps are listed below in typical order:
1.
Install the required software, as described in the previous section.
2.
Make sure that jumpers J3 and J4 are configured per the default set-
tings described in Section 2.5 - DEMOEM Jumper/Connector
Quick Reference.
tings described in Section 2.5 - DEMOEM Jumper/Connector
Quick Reference.
3.
Connect the DEMOEM Base Board to the PC via the USB cable.
4.
The operating system will recognize P&E’s Embedded Multilink cir-
cuitry and P&E’s USB to Serial circuitry. Depending on the operating
system, you may see the “Found New Hardware Wizard” dialog to
assist you with software installation for “PEMicro USB Multilink (i0).”
On Windows XP (SP2), the following dialog will appear:
cuitry and P&E’s USB to Serial circuitry. Depending on the operating
system, you may see the “Found New Hardware Wizard” dialog to
assist you with software installation for “PEMicro USB Multilink (i0).”
On Windows XP (SP2), the following dialog will appear: