Freescale Semiconductor Daughter Card for DEMOEM DCF51EM256 DCF51EM256 Manual De Usuario
Los códigos de productos
DCF51EM256
24
DEMOEM User Manual
6.4.2.2
Word Formatted Data
There are three commands which may be accepted. All commands must end
in the special characters #$0D and #$0A which are CR (carriage return) and
LF (line feed). The accepted commands are:
in the special characters #$0D and #$0A which are CR (carriage return) and
LF (line feed). The accepted commands are:
nnnn,nnnn,nnnn,nnnn
The nnnn values are 0000-FFFF and correspond in order to the data
displayed on both the graph and bar graphs as follows: X/A, Y/B, Z/C, W/D.
displayed on both the graph and bar graphs as follows: X/A, Y/B, Z/C, W/D.
nnnn:nnnn:nnnn:nnnn
The nnnn values are 0000-FFFF and correspond in order to the data
displayed the graphing component as follows: X, Y, Z, W.
displayed the graphing component as follows: X, Y, Z, W.
nnnn=nnnn=nnnn=nnnn
The nnnn values are 0000-FFFF and correspond in order to the data
displayed on the bar graph component as follows: A, B, C, D.
displayed on the bar graph component as follows: A, B, C, D.
7
JUMPER SETTINGS
7.1
System Power
7.1.1
J3 - Power Source Selection
The EM processor may obtain its power from the on-board regulator, USB
port, external battery, or through MCU_PORT J1. The on-board regulator
obtains its input from a 2.1mm barrel connector. The on-board regulator can
regulate the output to 3.3V. Power input is selected by using the J3, J4, and
J24 headers.
port, external battery, or through MCU_PORT J1. The on-board regulator
obtains its input from a 2.1mm barrel connector. The on-board regulator can
regulate the output to 3.3V. Power input is selected by using the J3, J4, and
J24 headers.
Select the USB port to supply microcontroller VDD. This is the default setting.
Figure 7-1: Power Source Selection Header (J3)