Freescale Semiconductor Daughter Card for DEMOEM DCF51EM256 DCF51EM256 Manual De Usuario

34

DEMOEM User Manual

Jumper 44 Connects PTE6 to the piezo buzzer circuitry.

The DEMOEM provides 5 jumpers, J19 through J23, for different VDD and 
VSS connections on the bottom of the board. By default, they are not 
populated and are shorted correspondingly with zero-ohm resistors in parallel, 
except J21 which is populated. The user may take off the zero-ohm resistor 
and install a corresponding jumper.

The DEMOEM includes P&E’s Embedded Multilink circuitry, so no external 
hardware BDM tool is needed to debug and program the DEMOEM. A user 
only needs to connect the DEMOEM to their PC to start developing code for it.

The DEMOEM package comes with an evaluation edition of Freescale’s 
CodeWarrior studio. In addition, P&E’s evaluation software for HCS08 and 
ColdFire® V1 is available in the DEMOEM Resources section of the Getting 
Started DVD, or online at www.pemicro.com. A user may use either 
CodeWarrior or P&E software tools to develop code for the DEMOEM.

The CodeWarrior for Microcontrollers studio supports Freescale’s HCS08 and 
ColdFire V1 devices. It offers C, C++, and assembly-level support, and 
provides debugging capabilities based on P&E’s debug and programming 
technologies.

A programming or debug session with the project-based CodeWarrior IDE 
may be launched by double-clicking on the project name (the format is 
projectname.mcp) from your file storage. The DEMOEM tutorials, FAQs, and 
quick start guide are easy to follow and will allow you use pre-built templates