Foxconn 45GMX-V Manual De Usuario

25

[Manual] - It means you can manually select a CPU clock to run your system. 
Any selected setting must be saved and exit BIOS to activate it.
More detailed descriptions of FIS feature can be found in FOX One utility of Chapter 4.

Press <Enter> to go to its submenu.

The following 5 settings are valid only when the Fox Intelligent Stepping is set to [Manual].

This option is used to set the CPU clock.

This option is used to set the speed of PCI Express slot. It may enhance the graphics card 
speed.

This option is used to regulate the CPU voltage.

This option is used to regulate the DRAM voltage.

If you enabled this function, it can significantly reduce the EMI (Electromagnetic Interference) 
generated by the system, so to comply with FCC regulation. But if overclocking is activated, 
you had better disable it.

This item is used to enable/disable provision of DRAM timing by SPD device. The Serial 
Presence Detect (SPD) device is a small EEPROM chip, mounted on a DDR2 memory 
module. It contains important information about the module's speed, si�e, addressing mode 
and various other parameters, so that the motherboard memory controller (chipset) can 
better access the memory device. Select [Manual], then you can configure DRAM timing by 
yourselves. 

Phoenix - AwardBIOS CMOS Setup Utility

DRAM Configuration

   

DRAM Timing Selectable 

[

By SPD

]

 

   

Item Help

   x  CAS Latency Time  

 Auto

   x  DRAM RAS# to CAS# Delay    Auto 

 

Menu Level  ►

   x  DRAM RAS# Precharge  

 Auto

   x  Precharge Delay (tRAS) 

 Auto

   x  System Memory Frequency 

 Auto

  ↑↓→←:Move   Enter:Select    +/-/PU/PD:Value   F10:Save     ESC:Exit   F1:General �elp         

                              

 F5: Previous Values            F7: �ptimi��ed Defaults

By SPD