Gw Instek GSP-9300 TGSpectrum analyzer, spectrum analyzerBandwidth (RBW) 1 Hz - 1 MHz (1-3-10) GSP-9300 TG Hoja De Datos
Los códigos de productos
GSP-9300 TG
GSP-9300 Programming Manual
74
SCPI Commands
*CLS ....................................................................................... 74
*IDN? ..................................................................................... 74
*ESE ....................................................................................... 75
*ESR? ..................................................................................... 75
*OPC ...................................................................................... 75
*RST ....................................................................................... 76
*SRE ....................................................................................... 76
*STB? ..................................................................................... 76
*TST? ..................................................................................... 76
*WAI ...................................................................................... 77
*CLS
Set
Description
The *CLS command clears the Standard Event
Status, Operation Status and Questionable Status
registers. The corresponding Enable registers in
each of the above registers are not cleared.
If a <NL> newline code immediately precedes a
*CLS command, the Error Que and the MAV bit in
the Status Byte Register is also cleared.
Status, Operation Status and Questionable Status
registers. The corresponding Enable registers in
each of the above registers are not cleared.
If a <NL> newline code immediately precedes a
*CLS command, the Error Que and the MAV bit in
the Status Byte Register is also cleared.
Syntax
*CLS
*IDN?
Query
Description
Queries the manufacturer, model number, serial
number, and firmware version of the instrument.
number, and firmware version of the instrument.
Query Syntax
*IDN?