Beurer PM 90 Heart rate monitor watch with chest strap Black/silver 676.10 Hoja De Datos

14 

You can wear your heart rate monitor like a wrist watch. If you would 
like to use the HR monitor when riding a bike, fix the monitor to the 
handlebars. This improves the signal transmission greatly. Use the 
assembly bracket supplied and fix the HR monitor firmly on to the 
handlebars so that the monitor does not slip when riding the bike.  

You can activate your heart rate monitor from the transport mode by 
pressing any button for 5 seconds. 

If the heart rate monitor has not received any signal for approx. five 
minutes, it switches to the power saving mode. At that point, only the 
current time and the date will be displayed. Press any button in order 
to reactivate the watch.  

„ 

Tighten the chest strap with the elastic tension belt. 
Adjust the length of the belt such that the belt is 
snug, but neither too loose nor too tight. Position 
the belt around the chest such that the logo is fac-
ing outwards and in the correct position directly 
over the breast bone. For men, the chest belt 
should be located directly below the pectoral mus-
cles, for women, directly below the breast.  

 

„ 

Since optimal contact between the skin and the heart rate sensors 
can not be created immediately, it may take some time until the 
heart rate is measured and displayed. If necessary, alter the posi-
tion of the transmitter in order to achieve optimal contact. Most of 
the time, sufficient contact is achieved through the accumulation