Analog Devices AD9743 Evaluation Board AD9743-DPG2-EBZ AD9743-DPG2-EBZ Hoja De Datos
Los códigos de productos
AD9743-DPG2-EBZ
Quick Start Guide
AD9741/3/5/6/7-EBZ
©2009 Analog Devices, Inc. All rights reserved. Trademarks and
registered trademarks are the property of their respective owners.
registered trademarks are the property of their respective owners.
D00000-0-1/07
GETTING STARTED – SINGLE TONE TEST
It is suggested that the basic set-up is verified before making any modifications to the evaluation board.
Basic Hardware Set-Up
Connect the equipment to the AD9747 evaluation board per the following table:
Equipment
Connects to AD9747 Eval Board
Power Supply)
P5 (+5V), P6 (GND
Signal Source
J1 (CLOCK IN), Set source to 100MHz, 2dBm output
PC USB Cable
XP2
Spectrum Analyzer
J5 (IOUT1_P) or J9 (IOUT2_P)
DPG2
P1 and P2
DPGDownloader Software
Power up the DPG and connect the USB cable to the PC. Next, run the DPGDownloader Software. A shortcut will be installed to your
Start menu during the installation of the DAC Software Suite. To begin, click on the DPGDownloader shortcut in your Programs menu,
typically at Start > Programs > Analog Devices > DPG > DPGDownloader.
Start menu during the installation of the DAC Software Suite. To begin, click on the DPGDownloader shortcut in your Programs menu,
typically at Start > Programs > Analog Devices > DPG > DPGDownloader.
The basic parts of the DPGDownloader window are; Hardware Config Panel, EVB Config, Vector Generation Pull-Down Menu, Vector
Palette, Vector Selection Panel and the Download and Play buttons.
Palette, Vector Selection Panel and the Download and Play buttons.
Figure 3 – DPGDownloader Window