C Control I Micro Chip 5 Vdc Inputs / outputs 1 x digital I/O, 1 x digital input, 4 x digital I/O or analog input Progra 198275 Hoja De Datos
Los códigos de productos
198275
42
Important! Read this!
Prior to commissioning the Programmer/Evaluation Board for C-Control
MICRO/MICRO-PCB or connected devices, read these operating instructions com-
pletely! It explains the correct handling and points out possible hazards.
MICRO/MICRO-PCB or connected devices, read these operating instructions com-
pletely! It explains the correct handling and points out possible hazards.
Conrad Electronics will not assume any liability for damages resulting from the non-
compliance with this manual. These damages are also not covered by the warranty.
compliance with this manual. These damages are also not covered by the warranty.
Content
Important! Read this! ............................................................................................42
Content......................................................................................................................42
Introduction ..............................................................................................................44
Warranty ................................................................................................................44
Service ..................................................................................................................45
Product Description ..................................................................................................46
Intended Use ........................................................................................................46
Safety Notices........................................................................................................46
Features ................................................................................................................47
Handling ....................................................................................................................48
Programmer/Evaluation Board ..............................................................................48
Connection of the C-Control Computers ..........................................................48
Connection to the PC ........................................................................................48
Power supply: ....................................................................................................48
Operating Elements............................................................................................48
Display Elements ................................................................................................49
Jumper for Configuration ..................................................................................49
C-Control Computer MICRO / MICRO PCB..........................................................50
Commissioning ........................................................................................................51
Software Installation ..............................................................................................51
The Programming Language CCBASIC....................................................................52
The Concept of C-Control MICRO/MICRO PCB ..................................................52
System Resources of the C-Control Computer ....................................................53
Realtime Clock (RTC) ........................................................................................53
User Bytes ..........................................................................................................53
Digital Ports ........................................................................................................53
Analogue Ports ..................................................................................................54
Frequency Input ................................................................................................55
Frequency Output - BEEP ..................................................................................55
39
Die Programme lassen sich laden, aber es tut sich nichts beim Start
- Sie haben das P/E-Board nicht richtig konfiguriert (Jumper)
- Sie haben eine Anwendung in welcher PORT3 beim Einschalten nicht auf log High
- Sie haben das P/E-Board nicht richtig konfiguriert (Jumper)
- Sie haben eine Anwendung in welcher PORT3 beim Einschalten nicht auf log High
liegt
- Ihre Anwendung braucht zu viel Strom und überlastet Spannungsregler oder Bat-
terie