Atmel Xplained Pro Evaluation Kit ATSAM4E-XPRO ATSAM4E-XPRO Hoja De Datos
Los códigos de productos
ATSAM4E-XPRO
897
SAM4E [DATASHEET]
Atmel-11157D-ATARM-SAM4E16-SAM4E8-Datasheet_12-Jun-14
Figure 38-10. Start Frame Delimiter
Drift Compensation
Drift compensation is available only in 16X oversampling mode. A hardware recovery system allows a larger clock
drift. To enable the hardware system, the bit in the USART_MAN register must be set. If the RXD edge is one 16X
clock cycle from the expected edge, this is considered as normal jitter and no corrective actions is taken. If the
RXD event is between 4 and 2 clock cycles before the expected edge, then the current period is shortened by one
clock cycle. If the RXD event is between 2 and 3 clock cycles after the expected edge, then the current period is
lengthened by one clock cycle. These intervals are considered to be drift and so corrective actions are
automatically taken.
drift. To enable the hardware system, the bit in the USART_MAN register must be set. If the RXD edge is one 16X
clock cycle from the expected edge, this is considered as normal jitter and no corrective actions is taken. If the
RXD event is between 4 and 2 clock cycles before the expected edge, then the current period is shortened by one
clock cycle. If the RXD event is between 2 and 3 clock cycles after the expected edge, then the current period is
lengthened by one clock cycle. These intervals are considered to be drift and so corrective actions are
automatically taken.
Figure 38-11. Bit Resynchronization
38.7.3.3 Asynchronous Receiver
If the USART is programmed in asynchronous operating mode (SYNC = 0), the receiver oversamples the RXD
input line. The oversampling is either 16 or 8 times the baud rate clock, depending on the OVER bit in the US_MR.
input line. The oversampling is either 16 or 8 times the baud rate clock, depending on the OVER bit in the US_MR.
The receiver samples the RXD line. If the line is sampled during one half of a bit time to 0, a start bit is detected
and data, parity and stop bits are successively sampled on the bit rate clock.
and data, parity and stop bits are successively sampled on the bit rate clock.
If the oversampling is 16, (OVER to 0), a start is detected at the eighth sample to 0. Then, data bits, parity bit and
stop bit are sampled on each 16 sampling clock cycle. If the oversampling is 8 (OVER to 1), a start bit is detected
at the fourth sample to 0. Then, data bits, parity bit and stop bit are sampled on each 8 sampling clock cycle.
stop bit are sampled on each 16 sampling clock cycle. If the oversampling is 8 (OVER to 1), a start bit is detected
at the fourth sample to 0. Then, data bits, parity bit and stop bit are sampled on each 8 sampling clock cycle.
Manchester
encoded
data
Txd
SFD
DATA
One bit start frame delimiter
Preamble Length
is set to 0
Manchester
encoded
data
Txd
SFD
DATA
Command Sync
start frame delimiter
Manchester
encoded
data
Txd
SFD
DATA
Data Sync
start frame delimiter
RXD
Oversampling
16x Clock
Sampling
point
Expected edge
Tolerance
Synchro.
Jump
Sync
Jump
Synchro.
Error
Synchro.
Error