Atmel Evaluation Kit AT91SAM9M10-G45-EK AT91SAM9M10-G45-EK Hoja De Datos
Los códigos de productos
AT91SAM9M10-G45-EK
72
SAM9M10 [DATASHEET]
6355F–ATARM–12-Mar-13
12.4.4.3
User Reset
The User Reset is entered when a low level is detected on the NRST pin and the bit URSTEN in RSTC_MR is at 1.
The NRST input signal is resynchronized with SLCK to insure proper behavior of the system.
The NRST input signal is resynchronized with SLCK to insure proper behavior of the system.
The User Reset is entered as soon as a low level is detected on NRST. The Processor Reset and the Peripheral
Reset are asserted.
Reset are asserted.
The User Reset is left when NRST rises, after a two-cycle resynchronization time and a 3-cycle processor startup.
The processor clock is re-enabled as soon as NRST is confirmed high.
The processor clock is re-enabled as soon as NRST is confirmed high.
When the processor reset signal is released, the RSTTYP field of the Status Register (RSTC_SR) is loaded with
the value 0x4, indicating a User Reset.
the value 0x4, indicating a User Reset.
The NRST Manager guarantees that the NRST line is asserted for EXTERNAL_RESET_LENGTH Slow Clock
cycles, as programmed in the field ERSTL. However, if NRST does not rise after EXTERNAL_RESET_LENGTH
because it is driven low externally, the internal reset lines remain asserted until NRST actually rises.
cycles, as programmed in the field ERSTL. However, if NRST does not rise after EXTERNAL_RESET_LENGTH
because it is driven low externally, the internal reset lines remain asserted until NRST actually rises.
Figure 12-6.
User Reset State
SLCK
periph_nreset
proc_nreset
NRST
NRST
(nrst_out)
>= EXTERNAL RESET LENGTH
MCK
Processor Startup
= 3 cycles
Any
Freq.
Resynch.
2 cycles
RSTTYP
Any
XXX
Resynch.
2 cycles
0x4 = User Reset