Atmel SAM4S-XPLD Atmel ATSAM4S-XPLD ATSAM4S-XPLD Hoja De Datos

 649

SAM4S [DATASHEET]

11100E–ATARM–24-Jul-13

The Slave Mode is defined as a mode where the device receives the clock and the address from another device called
the master.

In this mode, the device never initiates and never completes the transmission (START, REPEATED_START and STOP
conditions are always provided by the master).

The following fields must be programmed before entering Slave mode:

1.

SADR (TWI_SMR): The slave device address is used in order to be accessed by master devices in read or write 
mode.

2.

MSDIS (TWI_CR): Disable the master mode.

3.

SVEN (TWI_CR): Enable the slave mode.

As the device receives the clock, values written in TWI_CWGR are not taken into account.

After a Start or Repeated Start condition is detected and if the address sent by the Master matches with the Slave
address programmed in the SADR (Slave ADdress) field, SVACC (Slave ACCess) flag is set and SVREAD (Slave
READ) indicates the direction of the transfer. 

SVACC remains high until a STOP condition or a repeated START is detected. When such a condition is detected,
EOSACC (End Of Slave ACCess) flag is set.

In the case of a Read sequence (SVREAD is high), TWI transfers data written in the TWI_THR (TWI Transmit Holding
Register) until a STOP condition or a REPEATED_START + an address different from SADR is detected. Note that at the
end of the read sequence TXCOMP (Transmission Complete) flag is set and SVACC reset.

As soon as data is written in the TWI_THR, TXRDY (Transmit Holding Register Ready) flag is reset, and it is set when
the shift register is empty and the sent data acknowledged or not. If the data is not acknowledged, the NACK flag is set. 

Note that a STOP or a repeated START always follows a NACK.

See 

Host with

TWI

Interface

TWD

TWCK

LCD Controller

Slave 1

Slave 2

Slave 3

R

R

VDD

Host with TWI

Interface

Host with TWI

Interface

Master