Atmel SAM4S-XPLD Atmel ATSAM4S-XPLD ATSAM4S-XPLD Hoja De Datos
Los códigos de productos
ATSAM4S-XPLD
809
SAM4S [DATASHEET]
11100E–ATARM–24-Jul-13
37.
High Speed MultiMedia Card Interface (HSMCI)
37.1
Description
The High Speed Multimedia Card Interface (HSMCI) supports the MultiMedia Card (MMC) Specification V4.3, the SD
Memory Card Specification V2.0, the SDIO V2.0 specification and CE-ATA V1.1.
Memory Card Specification V2.0, the SDIO V2.0 specification and CE-ATA V1.1.
The HSMCI includes a command register, response registers, data registers, timeout counters and error detection logic
that automatically handle the transmission of commands and, when required, the reception of the associated responses
and data with a limited processor overhead.
that automatically handle the transmission of commands and, when required, the reception of the associated responses
and data with a limited processor overhead.
The HSMCI supports stream, block and multi block data read and write, and is compatible with the Peripheral DMA
Controller (PDC) Channels, minimizing processor intervention for large buffer transfers.
Controller (PDC) Channels, minimizing processor intervention for large buffer transfers.
The HSMCI operates at a rate of up to Master Clock divided by 2 and supports the interfacing of 1 slot(s). Each slot may
be used to interface with a High Speed MultiMedia Card bus (up to 30 Cards) or with an SD Memory Card. Only one slot
can be selected at a time (slots are multiplexed). A bit field in the SD Card Register performs this selection.
be used to interface with a High Speed MultiMedia Card bus (up to 30 Cards) or with an SD Memory Card. Only one slot
can be selected at a time (slots are multiplexed). A bit field in the SD Card Register performs this selection.
The SD Memory Card communication is based on a 9-pin interface (clock, command, four data and three power lines)
and the High Speed MultiMedia Card on a 7-pin interface (clock, command, one data, three power lines and one
reserved for future use).
and the High Speed MultiMedia Card on a 7-pin interface (clock, command, one data, three power lines and one
reserved for future use).
The SD Memory Card interface also supports High Speed MultiMedia Card operations. The main differences between
SD and High Speed MultiMedia Cards are the initialization process and the bus topology.
SD and High Speed MultiMedia Cards are the initialization process and the bus topology.
HSMCI fully supports CE-ATA Revision 1.1, built on the MMC System Specification v4.0. The module includes dedicated
hardware to issue the command completion signal and capture the host command completion signal disable.
hardware to issue the command completion signal and capture the host command completion signal disable.
37.2
Embedded Characteristics
4-bit or 1-bit Interface
Compatibility with MultiMedia Card Specification Version 4.3
Compatibility with SD and SDHC Memory Card Specification Version 2.0
Compatibility with SDIO Specification Version V1.1.
Compatibility with CE-ATA Specification 1.1
Cards clock rate up to Master Clock divided by 2
Boot Operation Mode support
High Speed mode support
Embedded power management to slow down clock rate when not used
MCI has one slot supporting
One MultiMediaCard bus (up to 30 cards) or
One SD Memory Card
One SDIO Card
Support for stream, block and multi-block data read and write