Atmel ARM-Based Evaluation Kit for SAM4S16C, 32-Bit ARM® Cortex® Microcontroller ATSAM4S-WPIR-RD ATSAM4S-WPIR-RD Hoja De Datos
Los códigos de productos
ATSAM4S-WPIR-RD
SAM4S Series [DATASHEET]
Atmel-11100G-ATARM-SAM4S-Datasheet_27-May-14
442
Figure 26-3.
NAND Flash Signal Multiplexing on SMC Pins
Note:
When NAND Flash logic is activated, (SMCNFCSx=1), NWE pin cannot be used i PIO Mode but only in
peripheral mode (NWE function). If NWE function is not used for other external memories (SRAM, LCD), it must be
configured in one of the following modes.
PIO Input with pull-up enabled (default state after reset)
PIO Output set at level 1
The address latch enable and command latch enable signals on the NAND Flash device are driven by address bits
A22 and A21of the address bus. Any bit of the address bus can also be used for this purpose. The command,
address or data words on the data bus of the NAND Flash device use their own addresses within the NCSx
address space (configured by CCFG_SMCNFCS Register on the Bus Matrix User Interface). The chip enable (CE)
signal of the device and the ready/busy (R/B) signals are connected to PIO lines. The CE signal then remains
asserted even when NCS3 is not selected, preventing the device from returning to standby mode. The NANDCS
output signal should be used in accordance with the external NAND Flash device type.
Two types of CE behavior exist depending on the NAND flash device:
Two types of CE behavior exist depending on the NAND flash device:
Standard NAND Flash devices require that the CE pin remains asserted Low continuously during the read
busy period to prevent the device from returning to standby mode. Since the Static Memory Controller (SMC)
asserts the NCSx signal High, it is necessary to connect the CE pin of the NAND Flash device to a GPIO
line, in order to hold it low during the busy period preceding data read out.
This restriction has been removed for “CE don’t care” NAND Flash devices. The NCSx signal can be directly
connected to the CE pin of the NAND Flash device.
illustrates both topologies: Standard and “CE don’t care” NAND Flash.
SMC
NRD
NWE
NANDOE
NANDWE
NAND Flash Logic
NCSx (activated if SMC_NFCSx=1) *
NANDWE
NANDOE
* in CCFG_SMCNFCS Matrix register