Mikroelektronika MikroE Development Kits MIKROE-258 Hoja De Datos
Los códigos de productos
MIKROE-258
MikroElektronika
The 3.3V-5V VOLTAGE TRANSLATOR board is capable of bidirectional adjustment of voltage signals, which means
that voltage signals may be sent and received at the same time (from 3.3V to 5V and vice versa). In bidirectional
mode, the position of jumpers depends on the voltage signal direction. For example, if voltage signals are sent from
a development system (3.3V) via the LSV0 pin, to a device (5V) via the HVS0 pin, it is necessary to place jumpers J1
and J9 in the position marked . At the same time, voltage signals may be sent from a device (5V) to a development
system (3.3V). In this case, voltage signals are sent from the HVS1 pin to the LVS1 pin, so that jumpers J10 and J2
should be placed in the position marked . These rules apply to all jumpers provided on the additional board. When
placing jumpers, pay attention to arrows next to jumpers. If arrows are in the opposite directions ( ), voltage signals
will not be properly sent/received (from 3.3V to 5V and vice versa).
Figure 4: 3.3V-5V VOLTAGE TRANSLATOR board connected to a development system
Figure 5: Dimensions of the additional board