STMicroelectronics VND5T100AJ Evaluation Board EV-VND5T100AJ EV-VND5T100AJ Hoja De Datos
Los códigos de productos
EV-VND5T100AJ
This is information on a product in full production. For further information contact your local STMicroelectronics sales
office.
office.
September 2013
Doc ID 023967 Rev 2
1/8
1
EV-VND5T100AJ
VND5T100AJ evaluation board
Data brief
−
production data
Features
■
Simple single IC application board dedicated
for VND5T100AJ-E
for VND5T100AJ-E
■
Provides thermal heat-sinking for ease of use
in prototyping.
in prototyping.
■
Provides electrical connectivity for easy
prototyping
prototyping
Description
EV-VND5T100AJ provides you an easy way to
connect ST’s surface mounted VIPower
connect ST’s surface mounted VIPower
®
drivers
into your existing prototype circuitry. This
evaluation board comes pre-assembled with
VND5T100AJ-E high-side driver.
evaluation board comes pre-assembled with
VND5T100AJ-E high-side driver.
The VND5T100AJ-E is a monolithic device made
using STMicroelectonics
using STMicroelectonics
®
VIPower
®
technology,
intended for driving resistive or inductive loads
with one side connected to ground.
with one side connected to ground.
Active V
CC
pin voltage clamp protects the device
against low energy spikes. This device integrates
an analog current sense which delivers a current
proportional to the load current.
an analog current sense which delivers a current
proportional to the load current.
Fault conditions such as overload,
overtemperature or short to V
overtemperature or short to V
CC
are reported via
the current sense pin. Output current limitation
protects the device in overload condition. The
device latches off in case of overload or thermal
protects the device in overload condition. The
device latches off in case of overload or thermal
shutdown. The device is reset by a low level pass
on the fault reset standby pin.
on the fault reset standby pin.
A permanent low level on the inputs and fault
reset standby pin disables all outputs and sets the
device in standby mode.
reset standby pin disables all outputs and sets the
device in standby mode.
Figure 1.
VND5T100AJ evaluation board
Parameter
Symbol
Value
Unit
Max transient supply voltage
V
CC
58
V
Operating voltage range
V
CC
8 to 36
V
Typ On-State resistance
R
ON
100
m
Ω
Current limitation (typ)
I
LIMH
22
A
Off-state supply current
I
S
2
µA
(1)
1.
Typical value with all loads connected.
Table 1.
Device summary
Order code
Reference
EV-VND5T100AJ
VND5T100AJ evaluation board