STMicroelectronics Discovery kit for STM32L100 Value line - with STM32L100RC MCU STM32L100C-DISCO STM32L100C-DISCO Hoja De Datos

DocID025091 Rev 1

29

PH0 and PH1 can be used as GPIO or as HSE oscillator. By default these I/Os are 
configured as GPIO, so SB16 and SB17 are closed, SB18 is open and R22, R23, C13 and 
C14 are not populated. 

An external HSE clock can be provided to the MCU in three ways: 
•

MCO from ST-LINK. From MCO of the STM32F103. This frequency cannot be 
changed, it is fixed at 8 MHz and connected to PH0-OSC_IN of the STM32L100RCT6. 
Configuration needed:

–

SB16, SB18 CLOSED

–

R22, R23 removed

–

SB17 OPEN

•

Oscillator onboard. From X2 crystal (not provided). For typical frequencies and its 
capacitors and resistors, please refer to the STM32L100RCT6 Datasheet. 
Configuration needed:

–

SB16, SB17 SB18 OPEN

–

R22, R23, C13, C14 soldered

•

Oscillator from external PH0. From external oscillator through pin 7 of the P1 
connector. Configuration needed:

–

SB16, SB17 CLOSED

–

SB18 OPEN

–

R22 and R23 removed

PC14 and PC15 can be used as GPIO or as LSE oscillator. By default these I/Os are 
configured as GPIO, so SB20 & SB21 are closed and X3, R24, R25 are not populated.

An external LSE clock can be provided to the MCU in two ways: 
•

Oscillator onboard. From X3 crystal (not provided). Configuration needed:

–

SB20, SB21 OPEN

–

C15, C16, R24 and R25 soldered.

•

Oscillator from external PC14. From external oscillator trough the pin 5 of P1 
connector. Configuration needed:

–

SB20, SB21 CLOSED

–

R24 and R25 removed