E-flite Carbon-Z EFL10250 Hoja De Datos

Problem

Possible Cause

Solution

Oscillation

Flying over recommended 

airspeed

Reduce air speed

Damaged propeller or 

spinner

Replace propeller or spinner

Imbalanced propeller 

Balance the propeller. For more information, view John Redman’s propeller balancing video at www.

horizonhobby.com

Flight condition variations

Adjust gain to current flight conditions (wind, updrafts, local conditions [elevation, humidity, 

temperature, etc.])

Motor vibration

Replace parts or correctly align all parts and tighten fasteners as needed

Loose receiver

Align and secure receiver in fuselage

Loose aircraft controls

Tighten or otherwise secure parts (servo, arm, linkage, horn and control surface)

Worn parts

Adjust gain to compensate for parts wear or replace worn parts (especially propeller, pivot points or 

servo)

Irregular servo rotation

Replace servo

Incorrect transmitter type 

(computerized or non-

computerized) assigned in 

receiver

Assign correct transmitter type in the receiver (refer to receiver manual)

If oscillation persists...  

Decrease gain (refer to receiver manual)

Trim change when 

flight mode is 

switched

Trim is not at neutral

If you adjust trim more than 8 clicks, adjust the clevis to remove trim

Sub-Trim is not at neutral

No Sub-Trim is allowed. Adjust the servo arm or the clevis

Incorrect response 

to the AS3X Control 

Direction Test

Incorrect direction settings 

in the receiver, which can 

cause a crash

DO NOT fly. Correct the direction settings (refer to the receiver manual), then fly. 

Channel 5 switch 

position 0 is 3D and 

position 1 is F3A

In your transmitter, Channel 

5 servo is set to REVERSE

In your transmitter, set Channel 5 servo to NORMAL