E-flite Carbon-Z EFL10250 Hoja De Datos

Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier) code of a single specific transmitter. You need to ‘bind’ your 
chosen Spektrum

™

 DSM2

®

/DSMX

®

 technology equipped aircraft transmitter to the receiver for proper operation. 

Please visit www.bindnfly.com for a complete list of compatible transmitters.

CAUTION: When using a Futaba

®

 transmitter with a Spektrum DSM module, you must reverse the throttle channel and rebind. Refer to your Spektrum 

module manual for binding and failsafe instructions. Refer to your Futaba transmitter manual for instructions on reversing the throttle channel.



Read the transmitter instructions for binding to a receiver (location of transmitter’s Bind control). 

 

1.

 

Make sure the transmitter is powered off.

2.

 

Move the transmitter controls to neutral (flight controls: rudder, elevators and ailerons) or to low  
positions (throttle, throttle trim).**

3.

 

Install a bind plug in the receiver bind port.

4.   Connect the flight battery to the ESC, then power on the ESC switch. The ESC will produce a series 

of sounds. One long tone, then 6 short tones confirm that the LVC is set correctly for the ESC. The 
orange bind LED on the receiver will begin to flash rapidly. 

5.

 

Power on the transmitter while holding the transmitter bind button or switch. Refer to your  
transmitter’s manual for binding button or switch instructions.

6. 

When the receiver binds to the transmitter, the orange bind light on the receiver will turn solid and the 

ESC will produce a series of three ascending tones. The tones indicate the ESC is armed, provided the 

throttle stick and throttle trim are low enough to trigger arming.  

7. 

After binding, the 3 LEDs (blue, yellow and red) on the receiver will flash. The flashing indicates the 

gain setting for each axis. The quicker the flash, the higher the gain setting. For more information, 

refer to the “Initializing the AR635” section in the receiver manual.

8.

 

Remove the bind plug from the bind port.

9.

 

Safely store the bind plug (some owners attach the bind plug to their transmitter using two-part loops 

and clips).

10.

  The receiver should retain the binding instructions received from the transmitter until another binding 

is done.

** The throttle will not arm if the transmitter’s throttle control is not put at the lowest position. If you encounter problems, follow the binding instructions and refer
to the transmitter Troubleshooting Guide for other instructions. If needed, contact the appropriate Horizon Product Support office.

Red: R

oll (
Ailer

ons)

Blue: P

itch (Elev

ator)

Gr

een: Y

aw 

(Rudder)