Siemens SPS starter kit 6ED1057-3BA00-0AA8 12 Vdc, 24 Vdc 6ED1057-3BA00-0AA8 Hoja De Datos
Los códigos de productos
6ED1057-3BA00-0AA8
Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
70
Manual, 06/2014, A5E33039675
You have now entered the first block. LOGO! automatically assigns a block number to each
new block. If you assign a name to the block, LOGO! shows the block name instead of the
block number. You can assign a block name as required:
Press to move the cursor to "B1".
Press to move the cursor to "B1".
Press OK and the cursor is now displayed as a flashing solid square. Now you can press
and to list the alphabet, numbers and special characters, either in ascending or
descending order. For more information on the available character set, refer to Section
"Assigning a circuit program name (Page 73)".
After you complete the change, press OK to confirm.
You then connect the block inputs as follows:
Press to position the cursor on In1 and press OK to select editing mode.
Press or to select the digital input list. The first element of the digital input list is the
After you complete the change, press OK to confirm.
You then connect the block inputs as follows:
Press to position the cursor on In1 and press OK to select editing mode.
Press or to select the digital input list. The first element of the digital input list is the
"Input 1", namely "I1". You can press to move the cursor to the input number, and then use
or to select the desired input (I1 to I24).