Siemens SPS starter kit 6ED1057-3BA00-0AA8 12 Vdc, 24 Vdc 6ED1057-3BA00-0AA8 Hoja De Datos
Los códigos de productos
6ED1057-3BA00-0AA8
Programming LOGO!
3.8 Configuring additional functions for LOGO!
LOGO!
100
Manual, 06/2014, A5E33039675
5. Press OK to confirm "
②
". LOGO! displays the following view:
6. The display now shows the default IP address of your LOGO!. To change the setting,
press OK. When the cursor appears in a flashing solid square, press or to move the
cursor to a position where you want to modify the number, then press or to increase
or decrease the number. To confirm your change, press OK.
LOGO! stores up to four addresses that you set previously. To view your last settings,
LOGO! stores up to four addresses that you set previously. To view your last settings,
press to move the cursor to the " " symbol, and then press OK to open a drop-down
list, for example:
You can press or to select a previously configured address in the list, and then press
OK to comfirm.
7. Press or to move to the subnet mask setting. The default subnet mask is as shown
above. To change the setting, press OK. When the cursor appears in a flashing solid
square, press or to move the cursor to a position where you want to modify the
number, then press or to increase or decrease the number. To confirm your change,
press OK.
8. Press to move to the gateway address setting. The default gateway is as shown above.
To change the setting, press OK. When the cursor appears in a flashing solid square,
press or to move the cursor to a position where you want to modify the number, then
press or to increase or decrease the number. To confirm your change, press OK.
Transferring the circuit program to LOGO!Soft Comfort
After you have finished the network settings, you can transfer the circuit program from
LOGO! to LOGO!Soft Comfort using the transfer command LOGO!→PC in LOGO!Soft
Comfort. For further information on uploading the circuit program to LOGO!Soft Comfort with
this transfer menu command, refer to the Online Help for LOGO!Soft Comfort.
3.8.2
Configuring a UDF (User-Defined Function)
You can configure UDF (User-Defined Function) blocks only from LOGO!Soft Comfort.
A UDF block is a preconfigured circuit program that you create in LOGO!Soft Comfort. You
A UDF block is a preconfigured circuit program that you create in LOGO!Soft Comfort. You
can add it to an existing circuit program as you do with a function block. For a detailed
description of the UDF configuration in LOGO!Soft Comfort, refer to the Online Help for
LOGO!Soft Comfort.