Siemens SPS starter kit 6ED1057-3BA00-0AA8 12 Vdc, 24 Vdc 6ED1057-3BA00-0AA8 Hoja De Datos
Los códigos de productos
6ED1057-3BA00-0AA8
LOGO! installation and wiring
2.2 Installing/removing LOGO!
LOGO!
Manual, 06/2014, A5E33039675
Manual, 06/2014, A5E33039675
35
2.2.2
Wall-mounting
Follow the instructions below to wall-mount LOGO! by means of two mounting slides and two
M4 screws (tightening torque 0.8 Nm to 1.2 Nm).
Note
When you do not wall-mount LOGO!, always keep the mounting slides in the factory default
When you do not wall-mount LOGO!, always keep the mounting slides in the factory default
positions, that is, within the data area given in the illustration above; otherwise, the mounting
slides may deform if they are exposed to hot and humid surroundings for a long term.
Drilling template for wall-mounting
Before you can wall-mount LOGO!, you need to drill holes using the template shown below:
All dimensions in mm
Bore hole for M4 screw, tightening torque 0.8 Nm to 1.2 Nm
Bore hole for M4 screw, tightening torque 0.8 Nm to 1.2 Nm
①
LOGO! Base Module