DELL E2313H 905-XT168-UK Hoja De Datos
Los códigos de productos
905-XT168-UK
Auto Log Print
On
Automatically prints a job history report after every 20
jobs.
Off
Does not automatically print a job history report after
every 20 jobs.
RAM Disk
Off
Does not allocate RAM for the disk file system. Secure
Print, Private Mail Box Print, Public Mail Box Print, and
Proof Print jobs will abort and be recorded to the job log.
Available Range: 50–300MBytes
Allocates RAM for the disk file system automatically.
(in 50 MB increments)
(in 50 MB increments)
Fax Server Address Book
On
Enables the server address book for fax numbers.
Off
Disables the server address book for fax numbers.
E-mail Server Address Book On
Enables the server address book for e-mail addresses.
Off
Disables the server address book for e-mail addresses.
Apply New Settings
After you change the settings, click this button to apply
the changes.
Restart printer to apply new settings
Click this button to apply the changes.
*1
When you specify 1 minute for Sleep, the printer enters power saver mode 1 minute after it finishes a job. This uses much less energy,
but requires more warm-up time for the printer. Specify 1 minute if your printer shares an electrical circuit with room lighting and you
notice lights flickering.
Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer ready to operate with minimum
warm-up time.
Select a value between 1 and 30 minutes for the power saver mode if you want a balance between energy consumption and a shorter
warm-up period.
The printer automatically returns to the standby mode from the power saver mode when it receives data from the computer. You can
also return the printer to the standby mode by pressing the
notice lights flickering.
Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer ready to operate with minimum
warm-up time.
Select a value between 1 and 30 minutes for the power saver mode if you want a balance between energy consumption and a shorter
warm-up period.
The printer automatically returns to the standby mode from the power saver mode when it receives data from the computer. You can
also return the printer to the standby mode by pressing the
(Power Saver) button on the operator panel.
System Settings - Timers
Purpose:
To configure the auto clear time and time-out time.
Values:
To configure the auto clear time and time-out time.
Values:
Auto Reset
45 seconds
Sets the amount of time before the printer automatically
resets the settings on the operator panel to the defaults
1 minute
when no additional settings are made.
2 minutes
3 minutes
4 minutes
3 minutes
4 minutes
Fault Time-out
0
Sets the amount of time the printer waits before canceling
a job when the job stops abnormally.
Available Range: 3–300 seconds
Job Time-out
0
Sets the amount of time the printer waits for additional
data from the computer before it cancels the job.
Available Range: 5–300 seconds
Apply New Settings
After you change the settings, click this button to apply
the changes.
Restart printer to apply new settings
Click this button to apply the changes.
Understanding the Tool Box Menus
195