DELL E2313H 905-XT168-UK Hoja De Datos

18  

Loading print media properly helps prevent jams and ensures trouble-free printing.  
Before loading any print media, identify the recommended print side of the print media. This information is usually 

indicated on the print media package.  

Tray1 can hold: 

•  250 sheets of the standard paper. 

The optional 550-sheet feeder (tray2) can hold: 

•  550 sheets of the standard paper. 

The multipurpose feeder (MPF) can hold: 

•  150 sheets of the standard paper. 

The maximum dimensions of print media that tray1 and the optional 550-sheet feeder can handle are: 

•  Width — 148 mm (5.83 inches) to 215.9 mm (8.5 inches) 
•  Length — 210 mm (8.27 inches) to 355.6 mm (14.00 inches) 

The maximum dimensions of print media that the MPF can handle are: 

•  Width — 76.2 mm (3.00 inches) to 215.9 mm (8.5 inches) 
•  Length — 127 mm (5.00 inches) to 355.6 mm (14.00 inches) 

This section describes how to load letterhead. For details about loading print media other than letterhead, see 

To avoid paper jams, do not remove the tray while printing is in progress. 

Use only laser print media. Do not use ink jet paper in the printer. 

The pre-printed paper such as letterhead and pre-punched paper must be inserted bottom edge first with the print 

side facing down as shown below. 

Set Letterhead 2-Sided or 

Letterhead Duplex Mode

to Enable and Paper Type to 

Letterhead, Preprinted, or Prepunched from the operator panel or the printer driver even when you print on a single 

side of letterhead, pre-printed, or pre-punched paper. 

Loading Print Media