Datalogic PowerScan PD9500 PD9530-HPK1 Hoja De Datos

The STD-P090 is a stand for PowerScan

™

 9000 family bar code 

readers, for hands-free operation. It also helps to keep the reader's 

handle within the operator's reach.

The mounting kit supplied with the stand contains the following 

components:

•three self-tapping screws

•two adhesive strips

Insert the reader into the stand as shown at left. Rotate the holder 

as needed to position the reader for the best orientation with 

respect to the bar codes.

To assemble the STD-P090 proceed as follows, referring to 

the figure at right:
1.

Connect the left and right supports (1) and fix them to 

the central support (2) with the positioning screw (3).

2.

Push the bridge (6) down onto the supports and wedge 

into place.

3.

Position the assembly by screwing the central support (2) 

into the tube (4).

4.

Position the assembly onto the base by fixing the tube 

(4) onto the base with the fixing screw (5).

The STD-P090 can be mounted to any surface using either the 

three self-tapping screws (8) or the two double-sided adhe-

sive strips (9); alternatively, the three adhesive bumpers can 

be used (7).

1.

Be sure that the STD-P090 is already assembled.

2.

Affix the STD-P090 base to the desired surface by means 

of the three self-tapping screws (8)

.

1.

Carefully clean the bottom surface of the base with alco-

hol to remove any impurities that could reduce the adhesion.

2.

Remove the protective plastic from one side of the adhesive strips (9) and stick them onto the bottom 

surface of the base.

3.

Remove the plastic from the other side of the strips and affix the STD-P090 to the desired surface.

©2014 Datalogic, Inc. • All rights reserved. • Datalogic and the 
Datalogic logo are registered trademarks of Datalogic S.p.A. in 
many countries, including the U.S.A. and the E.U.