Eurolite N-10 with ON/OFF controller 51701943 Hoja De Datos
Los códigos de productos
51701943
51701943_V_1_0_3046.DOC
17/35
For overhead use, always install a safety-rope that can hold at least 12 times the weight of the fixture. You
must only use safety-ropes with screw-on carabines. Pull the safety-rope through the attachment eyelet on
the rear panel of the device and over the trussing system or a safe fixation spot. Insert the end in the
carabine and tighten the safety screw.
must only use safety-ropes with screw-on carabines. Pull the safety-rope through the attachment eyelet on
the rear panel of the device and over the trussing system or a safe fixation spot. Insert the end in the
carabine and tighten the safety screw.
Use the safety-rope exclusively as a closed ring. Never use by only securing at each end. The maximum
drop distance must never exceed 20 cm.
drop distance must never exceed 20 cm.
A safety rope which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
DANGER TO LIFE!
Before taking into operation for the first time, the installation has to be approved by an expert!
Connection with the mains
Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
International
Brown
Live
L
Blue
Neutral
N
Yellow/Green
Earth
The earth has to be connected!
OPERATION
Switch the device on via the power switch. Connect the remote control with the Remote Control-socket.
After a certain warm-up time, the device is
ready to operate. Then the stand-by lamp of
the remote control lights up. By operating the
smoke switch on the remote control the smoke
emission starts. It may happen that the stand-
by lamp turns off and the smoke emission
stops. In this case the device is heating up
again and will be ready to operate in approx.
1-2 min. This process guarantees an
appropriate vaporization temperature and the
best smoke emission possible. The
temperature is regulated by a high quality
thermostat.
ready to operate. Then the stand-by lamp of
the remote control lights up. By operating the
smoke switch on the remote control the smoke
emission starts. It may happen that the stand-
by lamp turns off and the smoke emission
stops. In this case the device is heating up
again and will be ready to operate in approx.
1-2 min. This process guarantees an
appropriate vaporization temperature and the
best smoke emission possible. The
temperature is regulated by a high quality
thermostat.
CAUTION: The escape nozzle will heat up during operation. Therefore do not touch the nozzle until it
has cooled down completely.
has cooled down completely.