Brennenstuhl L130 1173390 Hoja De Datos

6

 

GB

Output, supply voltage and safety class:  
see identification plate

Note: Please ensure you read the following notes 
before installing the light. Make sure the power is 
switched off, before you install the light. The instal-
lation of the light should only be carried out by a 
qualified expert.

 This light may not be operated 

 

unless all sealing rings are located properly!

  

LED-lights are extremely bright. Under no cir-
cumstances look into the light beam of the LED 
lights, as this may cause permanent damage to 
your eyes.

  

1 m

FIRE HAZARD! Fit the light so that it 
is at least 1 m away from the material 
to be illuminated. Excessive heat can 

result in a fire.

  

 

If the glass is broken, it must be replaced 
with a new original Brennenstuhl pro-
tective glass before further use.

   

RISK OF INJURY FROM BURNS! Ensure the 
light has been switched off and allowed to 
cool before you touch it.

Note: The light has to be fitted to a dry, sturdy 
and stable surface according to the notes in Fig. A.

  

Mark the positions of the holes in the bracket and 
drill the respective holes into the wall. Affix the 
bracket to the wall using suitable screws.

  

Open the connection box of the light. Lead the 
power cable though the cable bracket and 

connect it to the screw terminal of the light ac-
cording to Fig. B. (N = blue cable, earth sym-
bol = green /yellow cable, L = brown cable). 
The light must be earthed! Please make sure 
that the cable is suitably fastened by the cable 
bracket.

  

Screw the top back on the connection box. 
Take care that the seal is positioned properly.

  

Affix the light to the bracket using the supplied 
screws and nuts. Align the light in the desired di-
rection and tighten the screws.

  

If possible ensure the motion sensor is not 
pointing to objects that are subject to large 
temperature differences, swimming pools, hot 
air exits or air conditioning units.

  

Avoid pointing the motion sensor onto trees or 
bushes, or towards places where pets often stay.

  

Please keep in mind when fitting the light that 
the motion sensor reacts most sensitively to 
movements through the detection area perpen-
dicular to it and the least sensitively to move-
ments directly towards it.

 

On the bottom of the light are three controls  
(see Fig. C).

Sensitivity (SENS):
Sensitivity means the maximum area where the  
movement sensor is triggered by movements. Turning 
the SENS-control clockwise increases the sensitivity.

Setting the timer (TIME):
The control TIME lets you choose a user defined 
lighting time of between 15 seconds and 5 minutes 
after the last movement has been registered. Turning 
the TIME-control clockwise increases the time span.

LED-Strahler_Content_L130-L130 PIR_EU.indd   6

25.05.12   15:55