Blade Nano QX BNF BLH7680 Hoja De Datos
Los códigos de productos
BLH7680
8
EN
1. Lower the throttle and throttle trim to the lowest settings.
2. Power on the transmitter.
3. Flip the quadcopter upside-down and install the battery by sliding it into the battery mounting slot below the
2. Power on the transmitter.
3. Flip the quadcopter upside-down and install the battery by sliding it into the battery mounting slot below the
4-in-1 control unit. Slide the battery into the slots with the label facing upward so that the battery key, molded into
the battery end-cap, comes in contact with the key on the battery slot.
the battery end-cap, comes in contact with the key on the battery slot.
4. Connect the battery cable to the 4-in-1 control unit, matching the red mark on the battery to the red mark on the
connector.
5. Place the nano QX on its skids on a fl at surface and leave the aircraft still until the LED on the 4-in-1 control unit is
solid blue (not blinking)
CAUTION: Always disconnect the Li-Po battery from the aircraft when not fl ying to avoid over-discharging the
battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged,
resulting in loss of performance and potential fi re when batteries are charged.
battery. Batteries discharged to a voltage lower than the lowest approved voltage may become damaged,
resulting in loss of performance and potential fi re when batteries are charged.
Installing the Flight Battery
1
2
3
4
3. Always disconnect the fl ight battery from the charger immediately upon completion of charging.
CAUTION: Only use chargers specifi cally designed to charge the included Li-Po battery. Failure to do so could
result in fi re, causing injury or property damage.
result in fi re, causing injury or property damage.
CAUTION: Never exceed the recommended charge rate.
LED Indications
When you make the connection successfully, the LED on the charger turns solid red, indicating charging has begun. Charging
a fully discharged (not over-discharged) 150mAh battery takes approximately 30–40 minutes. The light goes out when the
charge is complete.
When you make the connection successfully, the LED on the charger turns solid red, indicating charging has begun. Charging
a fully discharged (not over-discharged) 150mAh battery takes approximately 30–40 minutes. The light goes out when the
charge is complete.
CHARGING (Solid Red)
MAX CHARGE (OFF)
MAX CHARGE (OFF)
CAUTION: Once charging is complete, immediately remove the battery. Never leave a battery connected to the
charger.
charger.