Joy It Kit PC / Barebone without drives 4 ATi Radeon™ 3000 onBoard graphics Motherboard Gigabyte GA-78LMT-S2P JI FX-4100 Hoja De Datos

Hardware Installation

- 12 -

Use the upper port (green) to connect a PS/2 mouse and the lower port (purple) to connect a PS/2 keyboard.

The D-Sub port supports a 15-pin D-Sub connector. Connect a monitor that supports D-Sub connection 

to this port.

The DVI-D port conforms to the DVI-D specification and supports a maximum resolution of 1920x1200 
(the actual resolutions supported depend on the monitor being used). Connect a monitor that supports 
DVI-D connection to this port.

USB 3.0/2.0 Port j

The USB 3.0 port supports the USB 3.0 specification and is compatible to the USB 2.0/1.1 specification. 
Use this port for USB devices such as a USB keyboard/mouse, USB printer, USB flash drive and etc.

The Gigabit Ethernet LAN port provides Internet connection at up to 1 Gbps data rate. The following 

describes the states of the LAN port LEDs.

(Note)  The DVI-D port does not support D-Sub connection by adapter.

Activity LED

Connection/

Speed LED 

LAN Port

Activity LED:

Connection/Speed LED:

State 

Description

Orange

1 Gbps data rate

Green

100 Mbps data rate

Off

10 Mbps data rate

State 

Description

Blinking Data transmission or receiving is occurring
Off

No data transmission or receiving is occurring

When removing the cable connected to a back panel connector, first remove the cable from your 

 •

device and then remove it from the motherboard.

When removing the cable, pull it straight out from the connector. Do not rock it side to side to 

 •

prevent an electrical short inside the cable connector.

The USB port supports the USB 2.0/1.1 specification. Use this port for USB devices such as a USB key-

board/mouse, USB printer, USB flash drive and etc.

The default line in jack. Use this audio jack for line in devices such as an optical drive, walkman, etc.

The default line out jack. Use this audio jack for a headphone or 2-channel speaker. This jack can be 

used to connect front speakers in a 4/5.1/7.1-channel audio configuration.

The default Mic in jack. Microphones must be connected to this jack.

To enable 7.1-channel audio, you have to use an HD front panel audio module and enable the 

multi-channel audio feature through the audio driver.

j
k

 j  Only for GA-78LMT-USB3.   

 k  Only for GA-78LMT-S2P.