Lecroy WAVEACE 2034 4-channel oscilloscope, Digital Storage oscilloscope, WaveAce 2034 Manual De Usuario
Los códigos de productos
WaveAce 2034
WaveAce Remote Control
4
920836 Rev A
3. Enter an IP Address, Subnet Mask, and Gate Way. Enter values by selecting each segment
and turning the Adjust knob until the desired number is reached. Press the top soft key to
jump to the next field or press the Adjust knob to tab to the next segment of the current
field. Leave DHCP disabled.
jump to the next field or press the Adjust knob to tab to the next segment of the current
field. Leave DHCP disabled.
Program Messages
Program messages are composed of commands or queries separated by
semicolons
and ending
with a
terminator
:
<command/query>; . . . . . ;<command/query> <terminator>
Command/Query Syntax
The general form of a command or a query is an optional
header path
, followed by a command
header
, optionally followed by one or several
parameters
(shown as
<data>
in the following
construct):
NOTE: There is a space between the header and the first parameter.
Commas separate parameters.
The question mark [?] is optional and turns the command into a query.
The oscilloscope does not distinguish between upper- and lowercase characters.
Header path
Commands or queries that apply to a subsection of the oscilloscope, such as a single input
channel, must have their headers prefixed with a path name indicating the channel or trace
recipient of the command. It's recommended to always use header paths to minimize the risk
of error if the command order changes.
channel, must have their headers prefixed with a path name indicating the channel or trace
recipient of the command. It's recommended to always use header paths to minimize the risk
of error if the command order changes.