AEG DVD 4552 400462 Hoja De Datos

Los códigos de productos
400462
Descargar
Página de 66
English
42
Operation
Insert Batteries into the Remote 
Control/replace
 
WARNING:
Leaking battery acid may cause a health hazard. Remove batteries from 
the remote control when depleted or the unit is not in use for an ex-
tended period of time. Clean up any leakage with a cloth immediately. 
In the event of skin contact, rinse the afected area immediately. In case 
of ingestion consult a physician immediately. In the event of eye contact, 
rinse eyes and consult a physician immediately.
 
CAUTION:
Upon disposal, adhere to the recycle and environmental regulations of 
your respective country. Never throw batteries into open fire.
 
NOTE:
The lithium cell in the battery compartment of the remote has been 
 
K
protected with plastic foil for transport. This extends the lifetime of 
the battery. Before initial use, please remove this foil to prepare the 
remote control for use.
The life span of enclosed batteries may be reduced due to storage.
 
K
1.   Open the battery compartment on the bottom of the remote control. 
2.   Replace the cell with a battery of the same type (CR 2025). Pay atten-
tion to the polarity.
3.   Close the battery compartment again.
 
NOTE:
The signals of the remote control are transmitted to the DVD-Player 
by infrared light. Ensure that the DVD-Player is not exposed to direct 
sunlight. This may render the signal transmittal from the remote control 
to the DVD-Player impossible.
Remote Control Range  
To use the remote control point it toward the remote control sensor 
located at the front of the unit. The distance between remote control 
and sensor should not exceed 5 meters. The angle of the remote control 
to the sensor should not exceed 30 degrees within right, left, above and 
below.
Power Supply
A. Alternating Current Adapter
The alternating current adapter is functional with an alternating current of 
100 V and 240 V but:
The enclosed mains cable may only be connected to a power source 
 
K
of 230-240 V alternating current within Europe.
To connect to an alternating current source outside of Europe a plug 
 
K
adapter compatible with the respective outlet must be used.