Medisana WL450 45105 Hoja De Datos

1. 

2. 

3. 
        
4. 





Press and hold the Set-button       for about 3 seconds, until the time
in the display flashes. Adjust the time with the            and          buttons.
Press the Set-button       again to confirm the time. After that, you may
select one of two alarm settings (AL1 or AL2) or the Zizz (short time
alarm) for adjustment with the          ,          and       buttons.
The adjustment needs to be done in the same way with the         ,           
and          buttons as for the time adjustment. Additionally you need to
select the way of alarming: By radio (FM) or by nature sounds (Sound).
Depending on your selection you then need to adjust either the radio
frequency or one of the eight nature sounds. In the following you need to
set the volume and the light brightness level. If you only want to use the
light or sound/radio function, adjust the other function to 0. 
If you do not press a button for at least 10 seconds, the device will quit
the setting mode automatically. To activate an alarm you need to press
the corresponding button (see 3.5 Activate an alarm resp. 3.6 Short time
alarm). In case an alarm is activated, the L-Mode-       and S-Mode-
buttons are not available.

►

◄









►

◄







►

◄











With the S-Mode-button       you can choose a sound source. With each
press  on  the  button  you  change  the  source  in  this  sequence:  SOUND 
(nature  sounds)  -  FM  (radio)  -  MPS  (MP3  player)  -  OFF.  If  you  have 
chosen the nature sounds, you additionally need to select one of the eight
sounds with the           and           buttons. For listening to MP3 music, a
MP3 player with 3.5mm jack plug needs to be connected to the connector
for MP3 player       and needs to be switched on. The volume can be con-
trolled with the buttons      and     .                                                           

 g



►

◄











Place  the  device  on  a  solid  and  flat  surface  for  use  to  ensure  that  it
cannot tip over or fall down.                                                                

 

G

Position the device about 40 - 50 cm away from your head, for exam-
ple on a bedside table.                                             

                          

G

Plug the cable antenna to the the connector for cable antenna        on
the rear side of the device.             

                                                     

G

Plug the mains cable end to the connector for power cable        on the
rear side of the device and the power adapter to the wall outlet.    

   

 G

The packaging can be reused or recycled. Please dispose properly of any 
packaging material no longer required. If you notice any transport damage 
during unpacking, please contact your dealer without delay.                    

G