Harbor Freight Tools 3.2 Amp Variable Speed Jig Saw Manual Del Producto
Page 9
For technical questions, please call 1-888-866-5797.
Item 69436
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Disengage the Lock ON Button, release the Trigger and unplug the tool from
its electrical outlet before adjusting tool or installing accessories.
Installing the Blade
Figure B
Screw
Blade
Clamp
Blade
Holder
Blade
Guide
Wheel
1. Loosen the Screws on the Blade Holder.
2. If a Blade is already installed, pull the
old Blade out of the Clamp.
3. Slide the new blade (sold separately) all the way
into the Blade Clamp opening with the teeth
pointing forward and the back of the Blade pressed
against the center recess of the Guide Wheel.
4. Tighten the Screws to secure the Blade in place.
5. Pull the blade straight down with a gloved hand
to check that the blade is secured in place.
Adjusting the Cutting Angle
Figure C
Hex Wrench
Teeth
Screws
Base
1. Loosen the two Screws on the
bottom of the Baseplate.
2. Pull the Baseplate out and tilt it to the desired
angle between 0
° and 45° to the right or left.
3. Release the Baseplate, checking that the pin on the
body is engaged between the Teeth of the Baseplate.
4. Tighten the Screws on the Baseplate in place.
SAFETY
OPERA
TION
MAINTENANCE
SETUP