Inter-Tel CS-5400 Manual De Usuario

Page  124

Endpoint Feature Codes

Record-A-Call

385

If the system is programmed with a Record-A-
Call application, the endpoints can be pro-
grammed to use the Record-A-Call feature. It 
allows users to enter a feature code whenever 
they want to record an ongoing call in their 
designated Record-A-Call mailbox. Users can 
retrieve the recorded messages later, just as 
they would any other mailbox messages. 

Redial

380

Redials the last outside phone number dialed 
or saved at the endpoint (up to 48 digits). Also 
used to save numbers at endpoints pro-
grammed for last number saved. (Inter-Tel 
endpoints use the REDIAL button.)

Redirect Call

331

This feature allows the endpoint user to route 
ringing outside, intercom, and camped on 
calls to another endpoint, hunt group, or out-
side number. Routing of the redirected call is 
still subject to trunk and toll restrictions. This 
feature provides these options in addition to 
the currently available options which allow the 
endpoint user to redirect calls to Voice Mail or 
Do-Not-Disturb. The Redirect Ringing Call fea-
ture does not require any premium features. 

Reminder Message
Reminder Message Cancel

305
306

(Not used on single line endpoints) The end-
point user can set reminder messages that 
signal the endpoint at specific times. Or, the 
user can cancel all reminder messages for the 
endpoint.

Remote Programming

359

Allows a user to place an endpoint in DND 
mode, forward the endpoint’s calls, or change 
the password; either from another endpoint or 
through DISA.

Reverse Transfer (Call Pick-Up)

4

Picks up a call ringing or holding at an end-
point or hunt group

Review Keys

396

(Not used on single line endpoints) User-pro-
grammable feature buttons and Station Speed 
Dial buttons can be viewed using this feature 
code.

Ring Intercom Always On/Off

377

Enables/disables the feature that allows the 
endpoint to always place private (non-hands-
free) intercom calls.

Ring Tone Selection

398

(Not used on single line endpoints) Selects 
the type of ringing alert tone that will be heard 
from the endpoint.

Routing Off

304

Disables System OAI Offering Control for 
third-party applications. This feature requires 
you to enter a password. Once you disable 
routing, you cannot enable it again (i.e., only 
the third-party application can enable routing).