BENDIX SD-05-1200 Manual De Usuario

TENSION

NOTE: Some Bendix slack adjusters were manufactured

without a lubrication provision in the body; however,
the slack adjuster may be lubricated through the
cover as follows:

1. Remove rubber plugs from both covers and discard.

2. Determine which side of slack adjuster is accessible for

lubrication and install washer (Pc. No. 230156) and
grease fitting (BW Pc. No. 244017) Alemite #1625 using
Alemite tool #5254 to press grease fitting firmly in place
in cover.

3. Install steel plug (Pc. No. 244400) in other cover, making

certain it is firmly in place.

4. Lubricate slack adjuster. Apply a sufficient amount of

grease to completely fill body cavity.

1. Apply brakes and check that slack adjusters rotate freely

and without binding.

2. Release brakes and check that slack adjusters return

to the released position without binding.

3. With brakes released, check that the angle formed by

the slack adjuster arm and actuator push rod is greater
than 90 degrees. All slack adjusters should be set at
this same angle.

4. With brakes applied, check that the angle formed by

the slack adjuster arm and actuator push rod is still
slightly greater than 90 degrees. All slack adjusters
should be set at this same angle.

CAUTION: Before attempting to remove slack adjusters,
proper precautions should be taken so that an automatic
application of the actuators does not occur while removing
or installing slack adjusters, thus causing possible injury.
Decreasing air pressure can cause a sudden full brake
application without warning. Depending on type of system
on vehicle, it maybe necessary to drain all air reservoirs or
mechanically back off spring brake chambers.

A. REMOVAL

1. Remove the chamber push rod yoke pin.

2. Remove the retaining mechanism from end of brake

cam shaft.

3. Rotate the slack adjuster by turning the adjusting nut.

4. Slide the slack adjuster off of the spline end of the brake

cam shaft.

B. INSTALLATION

1. Install slack adjuster on brake cam shaft so the

adjustment screw and grease fitting (if so equipped) are
accessible for servicing.

2. Install retaining mechanism on end of brake cam shaft

to hold slack adjuster in place.

3. Turn adjusting nut to line up yoke pin hole with arm

hole. Install yoke pin and cotter pin.

4. Refer to steps 3 and 4 under “Service Tests” and make

sure the proper adjustments are made after installing a
slack adjuster.

When replacing one type of slack adjuster with another type,
it is necessary to match or exceed the torque rating and
match the arm length, yoke pin diameter, offset spline
diameter and width. It is also necessary to make certain
that there is adequate clearance at release and full stroke.

NOTE: Disassembly and assembly instructions apply only

to assemblies with riveted covers. Assemblies with
welded covers are considered non-serviceable and
are replaced as an assembly.

1. Remove rivets holding covers.

2. Remove welch plug.

PROVIDED THE MAXIMUM TORQUE RATING IS NOT EXCEEDED, BENDIX SLACKS CAN BE MOUNTED IN EITHER DIRECTION AND
STILL MEET THE ENGINEERING TEST SPECIFICATION (50K CYCLES AT MAXIMUM RATED LOAD). COMPRESSION MOUNTING IS

RECOMMENDED AND WILL YIELD A LONGER SERVICE LIFE.

COMPRESSION

ADJUSTING

SCREW

BRAKE

CHAMBER

SLACK

ADJUSTER

ADJUSTING

SCREW

SLACK

ADJUSTER

BRAKE

CHAMBER