Omega Lift 13120 Manual De Usuario

2

OIPM#13120-TJ2

Figure 1 - Model 13120 & 13200 Nomenclature

Save these instructions. For your safety, read, understand, and follow the information provided with and on this
jack. The owner and operator of this equipment shall have an understanding of this jack and safe operating
procedures before attempting to use. The owner and operator shall be aware that use and repair of this product
may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's
native language before use of this jack is authorized. If any doubt exists as to the safe and proper use of this jack,
remove from service immediately. Inspect before each use. Do not use if broken, bent, cracked or damaged parts
are noted. Any jack that appears damaged in any way, or operates abnormally shall be removed from service
immediately. If the jack has been or suspected to have been subjected to a shock load (a load dropped suddenly,
unexpectedly upon it), immediately discontinue use until jack has been checked by an Omega authorized service
center. It is recommended that an annual inspection be done by qualified personnel. Labels and Operator’s
Manuals are available from manufacturer (see Replacement Parts, page 6).

Omega Hydraulic Toe Jacks are designed for lifting, but not sustaining, loads ranging from 6 tons thru 10 tons
depending on the rated capacity of the jack. They are designed to be used vertically. After lifting, loads must be
immediately supported  by appropriate means. Each model is suitable for use in an appropriately rated and
designed vertical or bench press structure. These jacks are not recommended for use in lifting or positioning
construction trailers, houses and/or other building structures.

1. Verify that the product and the application are

compatible, if in doubt call Omega Technical
Service (888)332-6419.

2. Before using this product, read the operator's

manual completely and familiarize yourself
thoroughly with the product and the hazards
associated with its improper use.

3. Assemble handle sections by lining up spring clip of

smaller diameter handle section with slot of larger
handle section. Press down the spring clip and slide
smaller diameter section until clip is secure in slot.

4. With the notched end of the provided handle,

engage and open the release valve
(counterclockwise no more than 1/2 full turn).

5. With ram fully retracted, locate and remove the oil

filler plug/screw. Insert the handle into the handle
sleeve, then pump 6 to 8 strokes. This will help
release any pressurized air which may be trapped
within the reservoir. Ensure the oil level is just below
the oil filler plug/screw hole. Reinstall the oil filler
plug/screw.

6. Check to ensure that the pump operates smoothly

before putting into service. Replace worn or
damaged parts and assemblies with Omega
Authorized Replacement Parts only.

7. Inspect before each use. Do not use if bent, broken

or cracked components are noted.

handle sleeve

handle

head saddle

toe saddle

release valve

carry handle

oil filler plug / screw*

(not shown)

return spring

Base Size (L x W)

Model

Capacity

Lifting Range - Toe

Lifting Range - Head

6 Ton

7 1/2" X 4 5/8"

10 1/2" ~ 15 5/8"

13120

7/8" ~ 6"

10 Ton

7 1/2" X 5 3/8"

11" ~ 16 1/8"

13200

1 1/8" ~ 6 1/4"