Gossen Thermometer 15122 Manual De Usuario
GOSSEN Foto- und Lichtmeßtechnik
10
The EV in the display will blink to remind
you that the standard factory calibration has
been changed. Input of the correction in
1/3-stops in the range of ± 3 EV.
you that the standard factory calibration has
been changed. Input of the correction in
1/3-stops in the range of ± 3 EV.
For cancelling the correction value, remove
the battery from the compartment for a
moment and then put it back again.
the battery from the compartment for a
moment and then put it back again.
In case of over-exposure a positive
correction, in case of under-exposure
a negative correction value should be set.
correction, in case of under-exposure
a negative correction value should be set.
2.5 Function TIMER
A timer function is provided in the Digisix,
useful for long exposure or other timings
ranging from one second to thirty minutes.
– Use the function button to select the
A timer function is provided in the Digisix,
useful for long exposure or other timings
ranging from one second to thirty minutes.
– Use the function button to select the
function TIMER and hold it down until the
OK-signal sounds. The display shows the
last value used. The read-out will show
the "minutes" and will flash to allow the
countdown timer to be adjusted.
OK-signal sounds. The display shows the
last value used. The read-out will show
the "minutes" and will flash to allow the
countdown timer to be adjusted.
– Use the key M to enter the desired time
in minutes.
– Confirm by pushing the function button.
The read-out "seconds" in the display
will flash.
will flash.